- Inicio
- Marcas
-
Kits
- Combos
-
Recambios
SERPENT
- SERPENT 966
- SERPENT 747 / 748 / 750
- SERPENT GENERAL
- SERPENT 988/989/990/EVO/R
- SERPENT COBRA/GT/SRX8 GT
- SERPENT SPYDER SRX2
- SERPENT S100 PAN-CAR
- SERPENT SDX / SDX4 EVO
- SERPENT 411/PROJECT 4X
- SERPENT F110/S100/S120
- SERPENT SRX8 BUGGY / RTR
- SERPENT SHORT COURSE
- SERPENT COBRA TRUGGY
- SERPENT 988E/ 989E/ 990E
- SERPENT 720 - 733
- SERPENT 950 - 960
- SERPENT SRX8-E / RTR
- SERPENT SPYDER SRX2 Gen3
- SERPENT X23/24/25/26/RTR
- SERPENT TAIPAN PAN CAR
- SERPENT X20 FWD
- SERPENT SRX8 TRUGGY
- SERPENT X20 MINI
- SERPENT MINI SPYDER
- SERPENT F190
- Carrocerías
- Pinturas
- Motores nitro
- Motores eléctricos / ESC
- Motores gran escala
- Combustible
- Ruedas
- Electrónica
- Equipamiento
- Otros
- Ofertas
ULTIMATE 1/8 BUGGY PLASTIC WING BLACK V2
ALERON TRASERO PLASTICO 1/8 BUGGY NEGRO ULTIMATE V2
Esta es la versión V2 del Alerón Trasero de Plástico para 1/8TT de Ultimate Racing. Se puede usar tanto en buggy como en truggy. La diferencia con su predecesor son sutiles cambios en la forma permitiendo que el tren trasero "acompañe" mejor el giro tanto en curvas lentas donde se requiere mucho giro como en curvas rápidas que requieren mayor estabilidad.
Es habitual que los pilotos añadan agujeros en la parte trasera. El alerón Ultimate viene pre-marcado para que cada uno se haga los agujeros que quiera y del tamaño que quiera para permitir más flujo de aire. También viene pre-marcado con una rejilla por la parte inferior para que cada piloto pueda hacer los agujeros con precisión para montarlo en ángulo recto en cualquier vehículo de 1/8 todo terreno.
ULTIMATE 1/8 BUGGY PLASTIC REAR WING BLACK V2
This is the V2 version 1/8 off road Plastic Rear Wing from Ultimate Racing. It is intended for both, buggy and truggy. The differences from its predecessor are subtle changes in shape, allowing the rear end to follow the corner more effectively, both in slow corners where a lot of steering is required and in fast corners that demand greater stability.
It is common for racers to add holes to the back of the wing with hand trimming and tuning. The Ultimate wing has pre-marked locations to allow the opening of the rear dam to allow more wind flow. A grid is positioned and molded into the design to allow the racer to mount squarely and accurately to just about any 1/8th off-road vehicle.