- Home
-
Brands
- Kits
- Combos
-
Car parts
SERPENT
- SERPENT 966
- SERPENT 747 / 748 / 750
- SERPENT GENERAL
- SERPENT 988/989/990/EVO/R
- SERPENT COBRA/GT/SRX8 GT
- SERPENT SPYDER SRX2
- SERPENT S100 PAN-CAR
- SERPENT SDX / SDX4 EVO
- SERPENT 411/PROJECT 4X
- SERPENT F110/S100/S120
- SERPENT SRX8 BUGGY / RTR
- SERPENT SHORT COURSE
- SERPENT COBRA TRUGGY
- SERPENT 988E/ 989E/ 990E
- SERPENT 720 - 733
- SERPENT 950 - 960
- SERPENT SRX8-E / RTR
- SERPENT SPYDER SRX2 GEN3
- SERPENT X23/24/25/26/RTR
- SERPENT TAIPAN PAN CAR
- SERPENT X20 FWD
- SERPENT SRX8 TRUGGY
- SERPENT X20 MINI
- SERPENT MINI SPYDER
- SERPENT F190
- Body shells
- Paints
- Nitro engines
- Electric engines / ESC
- Fuel engines
- Nitro fuel
- Tyres
- Electronics
- Equipment
- Several
- Discounts
Molded-composite rear upright features built-in 0° of outboard toe to improve traction and prevent suspension geometry changes in serious crashes. This 1-hole upright may be used on high-traction tracks or tracks with long sweepers, since the position of the center hole will allow faster driving through those corners because of better cornering speed. More roll center positions can be easily adjusted by adding shims between the upright and the turnbuckle ball joint. The rear upright feature small but robust 5x10x4 ball-bearings to minimize unsprung weight.
Hard rigidity (labeled H ) specially optimized for foam-tire racing. For use on both left and right sides of the car.Can be also used for rubber tires.
No reviews
Comments (0)
No customer reviews for the moment.
Your review appreciation cannot be sent
Report comment
Are you sure that you want to report this comment?
Report sent
Your report has been submitted and will be considered by a moderator.
Your report cannot be sent
Write your review
Review sent
Your comment has been submitted and will be available once approved by a moderator.