FUTABA 3PV RADIO WITH R203GF RECEIVER

Futaba 3PV Transmitter with R203GF receiver 

T3PV Features: 

System: FHSS, S-FHSS & T-FHSS 2.4GHZ (T-FHSS / Telemetry only available with the optional R304SB(-E) receiver) 

3+1 Channels (the 4:th channel can only be used when 4WS mixing (crawlers) or Brake mixing and with a 4-channel receiver) 

Channel 3 can be used on SW1 (two endpoints) or at DT3 where the D/R normally is at (stepped function) 

10 Model Memory 

4-Character Model Name 

Sub-Trim (CH1-4) 

Channel-4 Trim (only visible if 4WS or Brake Mixing is activated) 

Steering Dual Rates (D/R) 

Steering End Point Adjustement (EPA-CH1) 

Throttle End Point Adjustement (EPA-CH2) 

Channel-3 End Point Adjustement (EPA-CH3) 

Channel-4 End Point Adjustement (EPA-CH4) - this is only displayed when 4WS or Brake Mixing is activated 

4-Wheel-Steering / Brake Mixing (SMX) (booth mixers can't be used at the same time) 

Sero Reverse (CH1-4) 

Steering Exponential (EXP-CH1) 

Throttle Exponential (EXP-CH2) 

Throttle Fail-Safe (F/S) 

ABS Brakes (3- cycle speeds available) 

Model Data Copy 

Auto Power-Off after 10 minutes 

Low Battery Alarm: 

4x AA alkaline batteries - set LBA @ 4.2V 

5 cell (6V) NiMH - set LBA @ 5.0V 

2S (6.6V) LiFe - set LBA @ 5.8V 

Available T-FHSS Telemetry Functions when using the R304SB(-E) receiver (not included): 

Receiver battery voltage (no sensor needed) 

External voltage (if this sensor is used the receiver battery voltage is not visible on the TX LCD) - SBS-01V 

No other telemetry sensors can be used 

Suitable Receivers: 

R203GF S-FHSS (included) 

R304SB(-E) T-FHSS (optional) - Use only Futaba Digital & BLS servos 

Optional TX Batteries: 

4x AA alkaline batteries (battery holder included) 

YT1800A (5 Cell NiMH) 

HT5F1800B / FPEBA0142 (5 Cell NiMH) 

FT2F1700B / FPEBA0140 (2S 6.6V LiFe) 

FT2F2100B / FPEBA0135 (2S 6.6V LiFe) 

T3PV-2.4G Transmitter: 

FHSS/S-FHSS/T-FHSS* system 

Wheel type 

3+1 channels (the 4th channel is used for mixing functions only) 

Transmitting frequency: 2.4GHz band 

Power requirement: Size AA Dry cell battery x 4 (6V) (or 5-cell NiMH / 2-cell LiFe) 

Current drain: 100mA or less 

Transmission antenna: 1/2ë di-pole (Built-in) 

Receiver R203GF (included): 

3 channels 

S-FHSS/FHSS auto detection system 

Power requirement: 4.8V ~7.4V battery (Dry cell battery cannot be used) 

Size: 39 x 26 x 10 mm (excluding a projection part) 

Weight: 8 g